ABSOLUTE MAXIMUM RATINGS (above which useful life may be impaired) | |||||
Positive Supply Voltage |
7 V | ||||
Negative Supply Voltage |
-4 V | ||||
Current at Amplifier Input |
±10 mA | ||||
Differential Input Current |
±10 mA | ||||
Maximum Continuous Power Dissipation (at 50°C still air) |
0.75 W | ||||
Storage Temperature |
-65 to +150°C | ||||
RECOMMENDED OPERATING CONDITIONS | |||||
Symbol | Minimum | Maximum | Unit | ||
Positive Supply Voltage |
VCC | 3 | 5 | V | |
Negative Supply Voltage |
VEE | -2 | -3.5 | V | |
Operating Temperature (still air) |
TA | - | 50 | °C | |
Operating Temperature (Air Flow 500 LFM) |
TFA | - | 75 | °C | |
Output Signal Current |
Imax | - | 20 | mA | |
ELECTRICAL CHARACTERISTICS | |||||
Measured at T = 25°C, VCC = +5.0 V, VEE = -2.5 V with AC coupled outputs and a load of 50 paralleled by 5 pF unless otherwise specified, for a package thermal resistance of 90°C/W. See test setup (Figure 1). | |||||
PARAMETERS |
|||||
Symbol | Minimum | Typical | Maximum | Unit | |
Positive Supply Current |
ICC | - | 40 | 50 | mA |
Negative Supply Current |
IEE | - | -25 | 30 | mA |
Quiescent Input Voltage |
VQI | -0.85 | -0.65 | -0.55 | V |
Input Noise (Note 1) |
IN | - | 65 | 100 | nA |
Input Resistance |
RI | 65 | 85 | 100 | |
Input Resistance Stability |
DRI | - | 0.3 | 0.45 | %/°C |
Input Capacitance |
CI | - | 4 | 6 | pF |
Input Protection (50 pF, 2 kV) |
E | 1 x 104 | - | - | J |
Gain (Note 2) |
G | 20 | 25 | 30 | mV/µA |
Gain Stability |
DG | - | 0.08 | 0.15 | mV/µA |
Quiescent Output Voltage |
VQO | 0 | 0.5 | 1 | V |
Maximum Positive Output Swing |
Vmax+ | 1 | 1.5 | - | V |
Maximum Negative Output Swing (Note 3) |
Vmax- | 75 | 150 | - | mV |
Integral Non Linearity (Note 4) |
L | - | 0.5 | 1.5 | % |
Output Resistance |
RO | 20 | 30 | 40 | |
Propagation Delay |
tPD | 3 | 5 | 7 | nsec |
Rise Time |
tR | - | 3 | 7 | nsec |
Fall Time |
tF | - | 5 | 7 | nsec |
Notes | |||||
1. Noise with no external capacitance at input and with the typical noise bandwidth of 100 MHz. | |||||
2. Gain measured with a 10 µA input signal. | |||||
3. Without external pull-down resistor. Can be extended by the use of a pull-down resistor. | |||||
4. For positive output voltage swing of 1 V with a load of > 50 . |