10Base-T1S-TD

• Trigger on Beacon, ID, ID + DATA, Commit/Sync, ESD and CRC-Error
• DATA trigger pattern setup can be less than full bytes and can be spread across bytes
• Conditional DATA trigger definition (<, <=, =, >, >=, <>, IN RANGE, OUT of RANGE)
• Conditional ID trigger definition (<, <=, =, >, >=, <>, IN RANGE, OUT of RANGE)
• Automatically identifying Node ID simplifies setting up the trigger /decoder
• Intuitive, color-coded decode overlays
• Interactive protocol table with zoom and pattern search

The automatic assignment of note ID to MAC address based on analyzing the PLCA cycle simplifies the setting up of the trigger / decoder function. Capability is provided to permit triggering on Beacon, ID, ID + DATA, Commit/Sync, ESD and CRC-Error.

The trigger permits a conditional (<. <=, =, >, >=, <>, inside a range, outside a range) setup for the DATA condition. This is especially useful in situations where abnormal events should be monitored, such as when a node broadcasts a low or high engine RPM or coolant pressure.

A transparent overlay with color-coding for specific portions of each protocol and the entire message frame makes it easy to understand your serial data information. Unlike other solutions, with protocol decode information away from the signal, our solution correlates the waveform and the protocol decode directly on the display. As the acquisition length is expanded or shortened, the decode overlay will adjust to show you just the right amount of information.

Turn the oscilloscope into a protocol analyzer with a tabular display of decoded information. Customize the table to show only the data of interest and touch a message in the table to automatically zoom to it and display it on the screen. Export the table for offline analysis. Up to four different decoded signals of any type may be simultaneously displayed in the table.